Monarch 9401®/9402 ®OptionsMemory CardOperator’s HandbookMonarch Marking SystemsTC9401MC Rev. A 9/94 ©1990-1994 Monarch Marking Systems, Inc. All
11. Remove the target card and press . You’ll see MEMORY CARDCard Copy >12. Turn the write-protect switch on both cards On to protectthe format
4. Press . You’ll seeCARD DELETEAll >5. Press . You’ll seeAre you sure?< YesDo one of the following:• To exit without deleting any forma
3. Type the password and press (refer to your SystemAdministrator’s Guide for information about passwords).You’ll seeMEMORY CARD< Card Delete4.
BatteryThe memory card uses a 3-volt lithium battery, type BR2325.Battery shelf life is approximately five years, with an active lifeof six months. T
To remove the insulating tab from the battery, perform thefollowing procedure:1. Hold the memory card with the Monarch logo facing upand the arrows po
Changing the BatteryCAUTIONIf any of the following conditions occur, the battery mayexplode:• a 3-volt lithium battery, type BR2325 is not used• the b
9401/9402 Memory Card Operator’s Handbook12
Published by the Technical Communications Department.Printed in U.S.A.For supplies, service, or assistance call:TOLL FREE:1-800-543-6650 (In the U.S.
Monarch 9401™/9402™OptionsUsing a Scanner with9401/9402 PrintersMonarch Marking SystemsA Pitney Bowes CompanyTC9401SC 6/90 ©1990 Monarch Marking
Each product and program carries a respective writtenwarranty, the only warranty on which the customer can rely.Monarch reserves the right to make cha
Each product and program carries a respective writtenwarranty, the only warranty on which the customer can rely.Monarch reserves the right to make cha
Table of ContentsUsing a Scanner...1Connecting the Scanner...
9401/9402 Operator’s Handbookii
OverviewYou can attach a scanner to a 9401 or 9402 printer. Using thescanner, you can automatically enter bar code information inyour formats.Here is
Setting the Printer1. From the Main Menu, press or until you seeMAIN MENU< Setup >2. Press . You’ll seeSETUPSupply >3. Press
7. Press until you seeSCANNER< Scanner Type8. Press . You’ll see the last selection, for exampleSCANNER TYPE< HP Smartwand >The optio
Selecting the Data Entry ModeThere are two ways to enter data on the 9401/9402 with ascanner.• In Auto Enter mode, the printer reads a successful scan
6. Press . You’ll see the last selection, for exampleSCANNERScanner Type >7. Press until you seeSCANNERAuto Enter >8. Press . You’l
Setting the M5763/M5764 ScannerThe M5763 and M5764 scanners require specific settings towork with the 9401/9402 printer.Before you begin using this sc
Table of ContentsUsing the Memory Card...1Write-protect Switch ...
For supplies, service, or assistance call:TOLL FREE:1-800-231-7700 (Service)1-800-543-6650 (Retail Sales)1-800-243-4015 (Industrial Sales)Print
Monarch 921™Supply DereelerOperating InstructionsMonarch Marking SystemsA Pitney Bowes CompanyTC0921OI 6/91 ©1991 Monarch Marking Systems, Inc. A
OverviewThe 921 Supply Dereeler holds large diameter supply rolls for9401/9402 printers. You can use up to 9.5" diameter rolls with4.0" dia
921 Operating Instructions2
Installation1. Turn off the printer power switch and unplug the powercord.2. Open the printer top cover.3. Remove the standard supply roll.4. Unsnap t
6. Position the Dereeler in back of the printer. Lift up theback of the printer and place the printer rear feet in theDereeler mounting holes as show
Loading Supplies1. Place the supply roll on the supply reel. NOTE: Maximum supply width is 2.5 inches.2. Feed the supply around the outside of the Der
921 Operating Instructions6
OperationWhen using large diameter supply rolls, operate the printer asyou normally would with the following exceptions:1. For ribbon operation, it ma
9401/9402 Memory Card Operator’s Handbookii
921 Operating Instructions8
Each product and program carries a respective writtenwarranty, the only warranty on which the customer can rely.Monarch reserves the right to make cha
Printed in U.S.A.For supplies, service, or assistance call:TOLL FREE:1-800-231-7700 (Service)1-800-543-6650 (Retail Sales)1-800-243-4015 (Indust
Using the Memory CardA memory card is a device used to store formats, check digitalgorithms, and MPCL packets. You can copy informationfrom a comput
The switch is located on the edge of the card next to thebattery cover.• The write-protect switch should be On for storing thememory card or printing
Inserting a Memory Card1. Be sure the write-protect switch is in the correct position.2. Position the card with the Monarch® logo facing up, andthe ar
Copying a Memory CardYou can copy formats from one memory card to another.To copy a memory card, you need • the source card (the memory card with the
5. Press . You’ll seeLoad Source CardPress ENTER._6. If you have not already done so, insert the source card inthe printer.7. Press . You’ll s
Comments to this Manuals