Paxar 9474 User Manual download pdf (Page 24)

If the field does not change, define IFLAG as ‘I’ and set

IVALUE to zero (0).

NOTE: Do not select incrementing on fields that contain a

check digit.

IVALUE One to three digits to define the amount by which the value in

the field increases or decreases as each ticket is printed. If

the field does not change, define IFLAG as ‘I’ and set IVALUE

to zero (0).

Values: 0-999

NOTE: The first number in the count sequence must contain

the same number of digits as the highest number to

be counted. For example, to count the numbers 1 to

999, the first number in the sequence must be entered

as 001.

ROW One to four digits to define the row location of the field on the

supply. This is the distance from the the guide edge zero

point at the bottom of the supply and the bottom of the field.

The zero point is 1.5 mm or 0.060 inches from the bottom of

the supply. The bottom of the supply is the edge that exits the

printer first.

This value is measured in tenths of millimeters (TOMMS) and

must be less than the maximum length of the supply.

Values: 0-2032

COL One to four digits to define the column location of the field on

the supply. This is the distance from the guide edge zero

point at the left edge of the supply and the left edge of the

field.

The zero point is 1.5 mm or 0.060 inches from the left edge of

the supply.

The unit of measurement is tenths of millimeters. The range

must be less than the maximum width of the supply.

Values: 0-1016 (0 to 4 inches)

MAG One to two digits as the magnification factor for the font of

text fields.

Values: 1 - 10

3-10 Message Structures

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 95 96

No comments

Paxar 9474 User Manual Page 24