Paxar 9430R User Manual



1-4 Getting Started Power (P) ButtonCharging the Battery The printer’s battery must be charged before using it. The battery can be charged ♦ using

Getting Started 1-5 Reading the LED This table explains the LED indicators. LED Indicators Status Red or OrangeOn The printer has an error and is

1-6 Getting Started Setting the DIP Switches Use the DIP switches to set the RS232 communication, IrDA, and optional RF values. Turn the printer ups

Getting Started 1-7 Connecting the Printer 1. Plug your host into the printer’s RS232 port using a modular connector. 2. Turn on the printer. 3. M

1-8 Getting Started Tab Attaching the Belt Clip 1. The printer comes with a belt clip. 2. Turn the printer over. 3. Attach the belt clip as shown.

Loading Supplies 2-1 LOADING SUPPLIES The printer can print text, bar codes, and some limited graphics on thermal direct receipt paper. See Appendi

2-2 Loading Supplies 3. Drop the supply into the well. Make sure the supply unwinds from the bottom as shown. 4. Position the supply between the

Loading Supplies 2-3 Using Different Size Supply Rolls The printer can use one, two, or three-inch wide supply rolls. However, you need to order the

2-4 Loading Supplies

Using the Printer 3-1 USING THE PRINTER This chapter includes information about printing and using the magnetic stripe reader. Printing Before you p

Each product and program carries a respective written warranty, the only warranty on which the customer can rely. Paxar reserves the right to make c

3-2 Using the Printer Quickly swipe the card through the reader either left-to-right or right-to-left with the magnetic stripe in the reader. The

Cleaning 4-1 Voids in printingCLEANING The rate and frequency at which you print determines how often you must clean the printer. We recommend clea

4-2 Cleaning 6. Clean the platen roller with a dry cloth or small brush. You can also use another cotton swab moistened with isopropyl alcohol. Tu

Troubleshooting 5-1 TROUBLESHOOTING If you cannot fix a problem, call Technical Support. Problem Action Does not feed or has a paper jam. Remove any

5-2 Troubleshooting Problem Action Light/heavy printing or voids in printing. ♦ Clean the printhead. ♦ Check or recharge the battery. See “Charg

Troubleshooting 5-3 Printing a Test Receipt Before calling technical support, print a test receipt. The test receipt has the printer’s firmware vers

5-4 Troubleshooting

Specifications A-1 SPECIFICATIONS Printer Specifications Height: 2.25 inches (57 mm) Width: 4.25 inches (108 mm) Length: 6.0 inches (152 mm) Weig

A-2 Specifications Charging Time: Approximately 1.5 hours Communications: RS-232 port, IrDA, Bluetooth Print Ratio 25% black maximum per square i

Specifications A-3 Options and Accessories ♦ Magnetic Card Reader (factory-installed) ♦ Extra Battery (125237) ♦ Shoulder Strap (125239) or Belt C

European Economic Area The European variant is intended for use throughout the European Economic Area, and is compliant with the R&TTE directives;

A-4 Specifications

i TABLE OF CONTENTS GETTING STARTED ... 1-1 Unpacking the Printer ...

ii

Getting Started 1-1 GETTING STARTED Use this Operator’s Handbook with your Paxar Monarch Sierra Sport™ 3R 9430R Printer. This three-inch printer

1-2 Getting Started Battery and Safety Information The printer is powered by a 6.0V Nickel Metal Hydride (NiMH) battery. ♦ Charging time in the p

Getting Started 1-3 Installing the Battery One battery may be included with the printer. The printer’s battery must be charged before using it. 1.